Install the Access Point on a Wall Using MBO-ART02 Articulating Mounting Bracket

About this task

Note

Note

The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It is replaced by the MBO-ART03 bracket.

For more information, see End of Sale and End Service Life.

Table 1. Hardware requirements for MBO-ART02 articulating mounting bracket wall installation
Quantity Item
1 Access point
1 MBO-ART02 articulating mounting bracket
6

M6 hex-head screws

Two M6 hex-head screws to attach the MBO-ART02 to the access point.

Four M6 hex-head screws to attach the MBO-ART02 bracket to the wall.
Note

Note

When using the MBO-ART02 articulating mounting bracket, set the minimum downward tilt to less than 20 degrees to prevent water ingress.

To install the access point on a wall:

Procedure

  1. Using the MBO-ART02 articulating mounting bracket‘s shorter bracket end as a template, mark and drill four holes on the wall.
    Click to expand in new window
    MBO-ART02 bracket template for attachment holes
    Image of the ART-02 extension arm mounting holes being marked.
  2. Attach the MBO-ART02 to the access point using four M6 hex-head screws.
  3. Align the mounting holes on the MBO-ART02 articulating mounting bracket against the holes on the wall and attach the bracket using four M6 hex-head screws.
  4. Adjust the bracket angles.
  5. Insert the lock screws and tighten their hex nuts.
  6. Attach the AP to the large bracket.
  7. Attach the LAN cables.
9037682-01 Rev AC