Install the Access Point on a Pole Using KT-147407-02 Bracket Parts

Before you begin

The following hardware is required for pole installation using KT-147407-02 bracket parts:

  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • Pole part of the KT-147407-02 bracket
  • Four M6 screws
  • Two hex-head M12 stainless-steel screws
  • Two hex-head M12 stainless-steel nuts
  • Two 0.5 in. wide stainless-steel cable clamps
  • One access point
Click to expand in new window
Pole part of the KT-147407-02 bracket
Image of the pole part of the KT-147407-02 bracket. The pole part is a square box metal bracket with step ridges on the top and bottom sides of the bracket.

Procedure

  1. Attach the KT-147407-02 flat part and 1-axis tilt part to the access point.
    For instructions on how to attach the bracket parts, see Install the flat part and the 1-axis tilt part of the KT-147407-02 bracket to the access point.
  2. Attach the KT-147407-02 pole part to the 1-axis tilt bracket using two M12 bolts through the large bracket holes on the 1-axis tilt bracket and the pole bracket.
  3. Fasten the bolts using two M12 hex nuts.
  4. Insert 0.5 in. stainless-steel cable clamp through the long slots on the pole bracket.
  5. Position the cable clamps on the pole bracket around a pole and attach the pole bracket.
  6. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11 in-lbs.
9036166-04 Rev AB