Install the Access Point on a Wall Using MBO-ART02 Articulating Mounting Bracket

About this task

Note

The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It is replaced by the MBO-ART03 bracket.

Table 1. Hardware requirements for MBO-ART02 articulating mounting bracket wall installation
Quantity	Item
1	Access point
1	MBO-ART02 articulating mounting bracket
6	M6 hex-head screws Two M6 hex-head screws to attach the MBO-ART02 to the access point. Four M6 hex-head screws to attach the MBO-ART02 bracket to the wall.

Note

When using the MBO-ART02 articulating mounting bracket, set the minimum downward tilt to less than 20 degrees to prevent water ingress.

To install the access point on a wall:

Using the MBO-ART02 articulating mounting bracket‘s shorter bracket end as a template, mark and drill four holes on the wall.

MBO-ART02 bracket template for attachment holes
Attach the MBO-ART02 to the access point using two M6 hex-head screws.
Use the mounting holes shown in Attach the MBO-ART02 bracket to the AP560h access point to mount the MBO-ART02 bracket onto the AP560h access point.

Attach the MBO-ART02 bracket to the AP560h access point
Align the mounting holes on the MBO-ART02 articulating mounting bracket against the holes on the wall and attach the bracket using four M6 hex-head screws.