About this task
Attach the access point to a pole using the WS-MBO-POLE01 bracket on MBO-ART02
articulating mounting bracket.
Note
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January,
2023. It is replaced by the MBO-ART03 bracket.
The 30520 wireless mounting kit is End of Sale
(EOS).
For more information, see End of Sale and End Service Life.
Table 1. Hardware requirements for pole
installation
| Quantity |
Item |
| 1 |
Access point |
| 1 |
MBO-ART02 articulating mounting bracket |
| 2 |
M6 hex-head screws to attach the MBO-ART02 to the access
point |
| 1 |
WS-MBO-POLE01 bracket |
| 4 |
M3 screws with nuts and washers to attach the WS-MBO-POLE01
bracket to the MBO-ART02 articulating mounting bracket |
| 2 |
Cable clamps |
Note
You must provide stainless-steel
cable clamps. The band must be 0.5 in. (12.7 mm) wide.
Procedure
-
Attach the MBO-ART02
articulating mounting bracket to the access point using two M6 hex-head
screws.
-
Attach the WS-MBO-POLE01 bracket to the MBO-ART02 articulating mounting bracket
using four M3 screws, nuts, and washers.
-
Attach both the cable clamps to the WS-MBO-POLE01 bracket.
Open the cable clamp by turning a flat bladed screwdriver counterclockwise.
Then insert the non-clamp end into the pole bracket through the holes.
-
Put the metal band around the pole and attach the WS-MBO-POLE01 bracket to the
pole.
Attaching the cable
clamps to the pole
-
Tighten the cable clamp screw clockwise, tightening the band around the
pole.
Tightening the cable clamps on the POLE01 bracket
