Install the Access Point Using
KT-147407-02 Bracket Parts and KT-150173-01 Extension Arm
Before you begin
The hardware required for installation:
Flat part of the KT-147407-02
bracket
1-axis tilt part of the
KT-147407-02 bracket
KT-150173-01 extension
arm
One access point
KT-150173-01 extension arm
About this task
The KT-150173-01 extension arm is used in combination with the wall and pole bracket
parts of the KT-147407-02 bracket.
Procedure
Attach the flat part of the
KT-147407-02 bracket to the access point using two M6 screws.
Place the flat part of the KT-147407-02 bracket inside the 1-axis tilt bracket,
and attach the 1-axis tilt bracket to the flat bracket using four M6
screws.
Using the KT-150173-01 extension
arm as a template, mark and drill four hole centers on a flat surface.
The holes must be within the
circular cuts in the end of the flange.
Attach one end of the KT-150173-01 extension arm to the 1-axis tilt bracket
using two hex-head M12 stainless-steel screws and two hex-head M12
stainless-steel nuts through the two large circular holes on the KT-150173- 01
extension arm.
Attach the KT-150173-01
extension arm, that now has the access point mounted on the other end, to a flat
surface using four M6 size hex-head screws.
Use screw-in anchors with the four M6 hex-head screws when you mount the
bracket on a wood surface and use concrete anchors for concrete surface.