Most ISW-Series switches can be DIN-rail mounted or
wall-mounted. The ISW 24GbP, 4-SFP model switch can be rack-mounted in a two-post rack,
but cannot be DIN-rail mounted or wall-mounted.
Mounting the ISW (DIN-Rail)
Mounting steps:
Screw the DIN-Rail bracket on with the bracket and screws in the accessory
kit.
Hook the unit over the DIN rail.
Push the bottom of the unit towards the DIN Rail until it snaps into place.
DIN-Rail Mounting
Mounting the ISW (Wall)
Attach the wall-mounting plates with
the screws provided in the accessory kit.
Mounting the ISW (Two-Post Rack)
This procedure uses the two-post mounting kit. The ISW 24GbP, 4-SFP switch can be
installed in a standard two-post equipment rack. It does not support Din-rail or
wall-mount options.
Take care to load the rack so that it is not top-heavy. Start installing equipment at
the bottom and work up.
Attach a rack ear to one side of
the switch, screwing it into the holes so that the flange (ear) is flush with
the front of the switch.
Attach the other rack ear to the
other side.
Attach the rack ears to the front
rack posts, using the screws (rack post screws not provided).
