ip pim (for a VLAN)
Enable PIM on the specified VLAN.
Syntax
-
default ip pim enable
-
default ip pim
hello-interval
-
default ip pim
join-prune-interval
-
ip pim active
-
ip pim enable
-
ip pim hello-interval
<0-18724>
-
ip pim join-prune-interval
<1-18724>
-
ip pim passive
-
no ip pim enable
Command Parameters
- active
- Enable PIM and configure the
interface type to active or passive to perform multicasting operations.
- enable
- Configure PIM for each interface
to enable the interface to perform multicasting operations.
- hello-interval <0-18724>
- Specify how long to wait (in
seconds) before the PIM switch sends out the next hello message to neighboring
switches.
- join-prune-interval <1-18724>
- Specify how long to wait (in
seconds) before the PIM router sends out the next join/prune message to its
upstream neighbors.
- passive
- Enable PIM and Configure the
interface type to passive simultaneously. By default, an enabled interface is
active.
Command Mode
VLAN Interface Configuration
