show isis logical-interface

Display IS-IS logical interfaces.

Syntax

show isis logical-interface [mtu] [name] [shaper]

Command Parameters

mtu: Displays IS-IS logical interface IDs, names, and the Maximum Transmission Unit (MTU) values.
name: Displays IS-IS logical interface name.
shaper: Displays IS-IS logical interface IDs, names, and egress shaping rate values in Mbps.
Note

Displays only interfaces with egress shaping rate values configured.

Default

The default is non.

Command Mode

User EXEC

Usage Guidelines

The mtu parameter only applies to XA1400 Series.

Command Output

The show isis logical-interface command displays the following information:


Output field	Description
BFD STATUS	Specifies the status of BFD on this logical interface. The status can be enabled or disabled.
IFIDX	Specifies an index value for this logical interface.
NAME	Specifies the administratively assigned name of this logical interface, which can be up to 16 characters.
ENCAP TYPE	Specifies whether the encapsulation type for the logical interface is Layer 2 (L2–P2P-VID) or Layer 3 (IP).
L2_INFO PORT/MLT	Specifies the port or MLT that the logical interface is connected to in an Layer 2 network.
L2_INFO VLAN	Specifies the list of VLANs that are associated with this Layer 2 logical interface.
TUNNEL DEST-IP	Specifies the destination IP address for the logical interface.
L3_TUNNEL_NEXT_HOP_INFO PORT/MLT	Specifies the outgoing interface (port or MLT) for VXLAN traffic.
L3_TUNNEL_NEXT_HOP_INFO VLAN	Specifies the outgoing VLAN interface for VXLAN traffic.
L3_TUNNEL_NEXT_HOP_INFO VRF	Specifies the name of the VRF that this Layer 3 logical interface is configured on.

9037340-00 Rev AA