show ip dhcp-relay fwd-path

Display information about Dynamic Host Configuration Protocol (DHCP) relay forward paths.

Syntax

show ip dhcp-relay fwd-path
show ip dhcp-relay fwd-path [vrf WORD<1-16>]
show ip dhcp-relay fwd-path [vrf WORD<1-16>] [vrfids WORD<0-512>]
show ip dhcp-relay fwd-path [vrfids WORD<0-512>]

Command Parameters

vrf WORD<1-16>: Specifies the name of the VRF.
vrfids <0-512>: Specifies the ID of the VRF. The value is an integer in the range of 0 to 512.

Default

None.

Command Mode

User EXEC

Command Output

The show ip dhcp-relay fwd-path command displays the following information:


Output field	Description
INTERFACE	Shows the VLAN or port associated with the respective relay interface.
SERVER	Specifies the server address.
ENABLE	Specifies if the DHCP-relay forwarding path from the client to the server is enabled on the switch.
MODE	Indicates the configured mode of this interface.
SRC PORT 67 Note: Exception: not supported on VSP 8600 Series.	Specifies that the UDP source port is 67 for BOOTP/DHCP relay request. The default is 68.

Example

The following example displays information about DHCP Relay forward paths.

Switch:1> show ip dhcp-relay fwd-path 

============================================================================
                          DHCP Fwd-path - GlobalRouter
============================================================================
INTERFACE       SERVER           ENABLE    MODE            SRC PORT 67
----------------------------------------------------------------------------
3.3.3.3         4.4.4.1          FALSE    DHCP & BOOTP      TRUE