Note
Per FCC requirement, the use of the Access Point on UNII-1 of 5GHz band requires installers to input antenna elevation gain during configuration if the AP placement is outdoors.This information can be found in Extreme antenna guide located at www.extremenetworks.com/support/.An AP-8533 external antenna Access Point supports the following dual band antenna options:
| Part Number | Antenna Type | 2.4 GHz Gain (dBi) | 5 GHz Gain (dBi) | Impedance (Ohms) |
|---|---|---|---|---|
| ML-2452-HPAG4A6-01 | Dipole | 4 | 7.3 | 50 |
| ML-2452-APAG2A1-01 | Dipole | 2.7 | 1.7 | 50 |
| ML-2452-HPA6-01 | Dipole | 5.3 | 6.1 | 50 |
| ML-2452-APA2-01 | Dipole | 3.17 | 4.85 | 50 |
| ML-2452-PNA5-01R | Panel | 5.5 | 6 | 50 |
| ML-2452-SEC5M4-N36 | Polarized Panel | 6.92 | 7.23 | 50 |
| ML-2452-PTA4M4-036 | Patch | 5 | 6.6 | 50 |
An AP-8533 internal antenna Access Point supports the following dual band antenna:
| Antenna Type | 2.4 GHz Gain (dBi) | 5 GHz Gain (dBi) | Impedance (Ohms) |
|---|---|---|---|
| Mono pole | 5.2 | 6.8 | N/A |
| Part Number | Antenna Type | 2.4 GHz Gain (dBi) | Impedance (Ohms) |
|---|---|---|---|
| ML-2452-APA2-01 | Dipole | 3.17 | 50 |
| ML-2452-HPA6-01 | Dipole | 5.3 | 50 |
| ML-2452-PNA7-01R | Panel | 8 | 50 |
| ML-2452-PNL3M3-1 | Panel | 9.7 | 50 |
| ML-2452-PNL9M3-N36 | Panel | 11 | 50 |
| AP-8533 Internal | Mono pole | 7.7 | N/A |