Cabling the Access Point using Power Injector

About this task

For Power Injector installations:

Procedure

  1. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector Data & Power Out connector and the Access Point‘s GE1/POE port.
  2. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and the Power Injector Data In connector.
  3. Ensure the cable length from the Ethernet source (host) to the Power Injector and Access Point does not exceed 100 meters (333 ft).
    The Power Injector has no On/Off power switch. The Power Injector receives power as soon as AC power is applied.
9035160