EU

Note

Note

Per FCC requirement, the use of the Access Point on UNII-1 of 5GHz band requires installers to input antenna elevation gain during configuration if the AP placement is outdoors. This information can be found in the Extreme Antenna Guide located at www.extremenetworks.com/support/.

An AP-8533 external antenna Access Point supports the following dual band antenna options:

Table 1. Dual Band 2.4 GHz / 5 GHz Wifi Antennas - EU
Part Number Antenna Type 2.4 GHz Gain (dBi) 5 GHz Gain (dBi) Impedance (Ohms)
ML-2452-HPAG4A6-01 Dipole 4 7.3 50
ML-2452-APAG2A1-01 Dipole 2.7 1.7 50
ML-2452-HPA6-01 Dipole 5.3 6.1 50
ML-2452-APA2-01 Dipole 3.17 4.85 50
ML-2452-HPAG5A8-01 Dipole 7.5 8 50
ML-2452-PNA5-01R Panel 5.5 6 50
ML-2452-PNA7-01R Panel 8 12 50
ML-2452-PTA4M4-036 Patch 5 6.6 50

An AP-8533 internal antenna Access Point supports the following dual band antenna:

Table 2. Dual Band 2.4 GHz / 5 GHz Internal Antennas - EU
Antenna Type 2.4 GHz Gain (dBi) 5 GHz Gain (dBi) Impedance (Ohms)
Mono pole 5.2 6.8 N/A
Table 3. Single Band 2.4 GHz Bluetooth Antennas - EU
Part Number Antenna Type 2.4 GHs Gain (dBi) Impedance (Ohms)
ML-2452-APA2-01 Dipole 3.17 50
ML-2452-HPA6-01 Dipole 5.3 50
ML-2452-PNA7-01R Panel 8 50
ML-2452-PNL3M3-1 Panel 9.7 50
ML-2452-PNL9M3-N36 Panel 11 50
AP-8533 Internal Mono pole 7.7 N/A