configure virtual-network remote-endpoint vxlan ipaddress

configure virtual-network vn_name [add | delete] remote-endpoint vxlan ipaddress ipaddress {vr vr_name}

Description

Use this command to add or remove a remote endpoint to a virtual network.

Syntax Description


`vn_name`	Alphanumeric string identifying the Virtual Network to be configured.
add	Add configuration to the virtual network.
delete	Delete configuration from the virtual network.
`ipaddress`	A remote endpoint IP address.
vr	VR/VRF instance the remote endpoint is associated with.
`vr_name`	An existing VR/VRF name.

Default

VR-Default.

Usage Guidelines

This command is only valid when the virtual network is operating in “flooding standard” mode. The remote endpoint will receive unknown destination frames of all types that enter the virtual network from the local endpoint. For "explicit-remotes" flooding mode, the remote endpoints are added when BUM FDB entries are added.

Example

To add a remote endpoint to an existing Virtual Network:

configure virtual-network my_virtual_network add remote-endpoint vxlan ipaddress 1.2.3.4

To remove a remote endpoint from an existing Virtual Network:

configure virtual-network my_virtual_network delete remote-endpoint vxlan ipaddress 1.2.3.4

History

This command was first available in ExtremeXOS 21.1.

Platform Availability

This command is supported on the ExtremeSwitching X670-G2, X465, X590, X690, X695, X870, 5420, 5520 series switches, and stacks with X465, X590, X670-G2, X690, X695, X870, 5420, 5520 slots only.