disable virtual-network remote-endpoint vxlan

disable virtual-network remote-endpoint vxlan [ ipaddress ipaddress {vr vr_name} | all ]

Description

Disables a VXLAN remote endpoint.

Syntax Description

virtual-network Virtual overlay network.
remote-endpoint Remote tunnel endpoint information.
vxlan VXLAN virtual networks remote endpoint.
ipaddress Specifies an IP address of a remote endpoint.
ipaddress Specifies the IP address of the desired remote endpoint.
vr Specifies a VR/VRF instance the remote endpoint is associated with.
vr_name Specifies the desired existing VR/VRF instance the remote endpoint is associated with. Default is VR-Default.
all Specifies all remote tunnel endpoints.

Default

If a VR is not specified, VR-Default is the VR.

Usage Guidelines

Extreme Loop Recognition Protocol (ELRP) detects loops across VXLAN tunnels. If a loop is detected across the tunnel, ELRP takes down the VXLAN remote endpoint. You can use this command to disable a remote endpoint manually.

Example

The following example disables the remote endpoint at 100.1.1.1 on VR-Default (not specified, command default):

# disable virtual-network remote-endpoint vxlan ipaddress 100.1.1.1

History

This command was first available in ExtremeXOS 22.4.

Platform Availability

This command is supported on the ExtremeSwitching X670-G2, X465, X590, X690, X695, X870,, 5420, 5520 series switches, and stacks with X465, X590, X670-G2, X690, X695, X870, 5420, 5520 slots only.