Add an entry to the unicast slave table for a PTP clock instance. This command is available only for boundary clocks.
| boundary | Boundary clock instance. |
| unicast-slave | IP addresses that are potential slaves to the local clock. |
| ipv4_address | IPv4 address. |
| vlan | VLAN. |
| vlan_name | Name of the specific VLAN to add for the PTP clock instance. |
The default configuration of clock port is slave mode.
Use this command to add an entry to the unicast slave table for a PTP clock instance.
The following command adds a static unicast slave entry to the PTP clock port lpbk-slave in the boundary clock:
# configure network-clock ptp boundary add unicast-slave 192.168.15.20 vlan lpbk-slave
This command was first available in ExtremeXOS 15.1.
This command is available on ExtremeSwitching X670-G2, and X460-G2 series switches.
Note
PTP commands can be used only with the Network Timing feature pack.