encap

Configures encapsulation parameters for the outgoing packets.

Syntax

encap name

no encap name

name: Specifies the name of the encap object. Supports 1-64 characters.; The name must start with an alphabet character or an underscore.

Config mode

Encap config mode

Validations for the command are as follows:

If the same command is run more than once, the second and subsequent instances are ignored and no error is reported.
If the no form of the command is run without the configuration, the command is ignored and no error is reported.
If the no form of the command is run with the configuration, all sub-mode configurations are removed along with the encap object.
The following reserved keywords cannot be used as name identifiers: all, ingress-group, egress, egress-group, match, list, access-list, route-map, and listener-policy.

The following example configures encapsulation parameters for encap-1.

device(config)# encap encap-1
device(config-encap-1)#