Install a Versatile Interface Module in a 5720 Series Switch

This topic describes how to install a versatile interface module (VIM) in the front slot of a 5720 Series switch.

You need the following tools and materials to install a VIM:

• ESD-preventive wrist strap

• Flat head screwdriver

To install a versatile interface module, follow these steps:

1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point on the rack.
2. Ensure that the switch is completely powered down.
   1. Use the screwdriver to loosen and remove the two retaining screws on the cover plate.

      

      Removing a slot Cover Plate (VIM slot cover shown)

      

      1 = VIM module retaining screw locations

   2. Remove the cover plate from the VIM slot.
3. Remove the new VIM from its anti-static packaging.
4. Install the VIM in the switch:
   1. Carefully slide the VIM module into the switch.
   2. Insert and tighten the retaining screws you previously removed, using the screws provided.

   

   VIM Module Inserted in Slot

   

   1 = VIM module retaining screw locations