Install an SSD Module

This topic describes how to install a Solid-State Drive (SSD) module in the rear slot of the 24MXW and 48MXW switch models.

You need the following tools and materials to install an SSD module:

• ESD-preventive wrist strap

• #2 Phillips screwdriver

Warning

To prevent damage to the switch or SSD module, the switch must be powered OFF when removing or installing SSD modules. SSD modules are not hot-swappable.

1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point on the rack.
2. Ensure that the switch is completely powered down.
3. Remove the rear panel blank from the SSD slot (#2 Phillips screwdriver required) in the rear of the switch.

   

   SSD Rear Panel Blank

   

   1 = SSD blank retaining screw location

4. Remove the SSD module from its packaging.
5. Carefully slide the SSD module into the slot on the rear panel until it is firmly in place.
6. Secure the SSD module using the screw provided.

   

   SSD Module Inserted in Slot

   

   1 = SSD module retaining screw location