Replace a Versatile Interface Module or Solid-State Drive

This section describes how to replace versatile interface modules (VIMs) or an SSD in the rear slot of an 5720 Series switch.

You need the following tools and materials to install a VIM:

• ESD-preventive wrist strap
• #2 Phillips screwdriver
  

  Caution

  VIMs and SSDs are not hot-swappable. Disconnect power to the switch before removing an installed a VIM or SSD, or installing a new one.

To replace a VIM or SSD:

1. Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate ground point on the rack.
2. Disconnect the switch power.
3. Remove the existing VIM or SSD:
   1. Remove the retaining screws holding the existing module in place.

      

      SSD Module Inserted in Slot

      

      

      VIM Module Inserted in Slot

      

   2. Save the retaining screws to secure the new module in the switch.
   3. Pull the old module out of the module slot.
4. Remove the new VIM or SSD module from its anti-static packaging.
5. Install the VIM or SSD in the switch:
   1. Carefully slide the module into the switch.
   2. Insert and tighten the retaining screws you removed in step 3.a.

      

      Tighten Screws to Secure the VIM Module

      

      

      Tighten Screw to Secure the SSD Module