Replace a 2000 W AC Power Supply

The ExtremeSwitching 2000 W AC power supply with part number XN-ACPWR-2000W-FB is compatible with all 5720 Series models.

These switches have two bays for hot-swappable power supplies. In a switch with a redundant power configuration, you can replace one AC power supply without powering down the switch.

You need the following tools and materials to replace a 2000 W AC power supply:

• Thermal protective gloves
• AC power cord, if you will not be re-using the cord from the removed power supply

To replace a 2000 W AC power supply, follow these steps:

1. Disconnect the AC power cord from the wall outlet and from the power supply.
2. Note the orientation of the installed power supply, and the location of the latching tab at the left of the unit.
3. Push the latching tab toward the power supply handle and pull outward on the handle to disengage the power supply internal connectors. See Removing an ExtremeSwitching 2000 W AC Power Supply.

   

   Removing an ExtremeSwitching 2000 W AC Power Supply

   

4. Carefully slide the power supply the rest of the way out of the switch.
   

   Caution

   Power supplies can become very hot during operation. Wear thermal protective gloves when you remove a power supply from an operating switch.
   

   Note

   If you are not installing a replacement power supply, install a cover over the unoccupied power supply bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI levels.
5. Verify that the replacement power supply is oriented the same way as the unit you removed, and has the same airflow direction.
6. Carefully slide the power supply all the way into the power supply bay, as shown in Installing an ExtremeSwitching 2000 W AC Power Supply.

   

   Installing an ExtremeSwitching 2000 W AC Power Supply

   

7. Push the power supply in until the latch snaps into place.
   

   Caution

   Do not slam the power supply into the switch.
8. Connect the power cord to the power supply and to a grounded AC power outlet.
   

   Warning

   Always be sure that the source outlet is properly grounded before plugging the AC power cord into the AC power supply.
9. If the power supply is equipped with a power cord retainer, use the retainer to secure the power cord to the power supply.