Install the EIO-04 Under-Seat Slope Bracket with the Access Point Against a Stadium Riser Slope Using EIO-GASKET

Learn how to install the EIO-04 under-seat enclosure with the AP560i access point on a flat surface, with EIO-GASKET sealing the space between the slope bracket and the stadium riser.

Before you begin

Table 1. Hardware requirements for flat surface installation
Item quantity Description
1 AP560i access point
4 M6 screws with integral washers
4 75 mm service panel shoulder screws
2 Metal "L" bracket
4 3mm stainless steel washers.
1 Plastic service panel base
1 Plastic service panel top with one captive screw
4 Concrete anchors with nuts, washers, anchor posts, and anchor sleeves
EIO-GASKET silicone rubber kit that ships with the under-seat enclosure:
Table 2. EIO-GASKET box contents (ordered separately)
Part number Box contents
EIO-GASKET Two silicone rubber gaskets
Two shoulder screws (security torx, T20 bit-size)
One URL card

About this task

The EIO-GASKET keeps the debris from getting between the ramp base and a wall or a stadium riser. The EIO-GASKET supports the EIO-04 ramp bases.

The EIO-GASKET is made of compressible silicone rubber.

The best practice is to use the EIO-GAKET when the ramp base cannot be pressure washed from behind or when debris can be pushed behind the ramp base by a pressure washer. For information on pressure washing guidelines, see Power or Pressure Washing Guidelines.
Note

Note

When you mount the AP on a riser with the metal "L" bracket only and not with a large metal sloping bracket, it is recommended that you add a 3mm-thick stainless steel washer between the “L” brackets and the riser on all of the anchors. The washer provides proper drainage during storms.
Click to expand in new window
EIO-GASKET
Silicone rubber gasket

Procedure

  1. Attach a metal “L” bracket on each side of the AP560i access point using two M6 screws for each bracket.
  2. Torque the M6 screws to 35 in-lbs.
  3. Use the metal “L” brackets as a template, mark four hole centers, and drill in the concrete.
  4. Insert four concrete anchors into the holes.
  5. Add a 3mm stainless steel washer to each anchor.
    The 3mm washers create a dranage channel for storm water and debris.
  6. Insert the 2 concrete anchors without the washers or nuts.
  7. Using a single security torx screw for each gasket attach a gasket to each side of the metal slope.
    Click to expand in new window
    EIO-GASKET screw
    Silicone rubber gasket with shoulder screw
    Callout Description
    1 EIO-GASKET made of compressible silicone rubber
    2 EIO-GASKET screw hole location for attaching the provided screw
    Click to expand in new window
    EIO-GASKET on a stadium riser
    EIO-GASKET installed on a 90 degree stadium riser
    Callout Description
    1 EIO-GASKET on a 90° stadium riser
  8. Place the metal slope over the threaded anchor posts and put on the flat-washer, the spring washer, and the nut on each side.
  9. Torque the nuts to 60 in-lbs.
    Click to expand in new window
    AP560i flat surface installation with metal “L” brackets
    Image of the access point after it is installed on the metal L brackets.
  10. Install the Plastic Service Panel on the Access Point.
9036165-04 Rev AB