Install the Access Point on a Pole with the MBO-ART03 and KT-147407-02 Brackets

Before you begin

The following hardware is required to install your access point to a pole with the MBO-ART03 and KT-147407-02 brackets.

Table 1. Hardware Requirements
Quantity	item
1	Access point.
1	KT-147407-02 bracket.
1	MBO-ART03 articulating mounting bracket.
2	M6 hex-head screws to attach the MBO-ART03 to the access point.
2	M6 screws with nuts and washers to attach KT-147407-02 to the MBO-ART03.
2	Long M6 Hex hex screws and nuts for providing an angular lock for each axis.
2	Cable clamps with a band of 0.5 in. (12.7 mm). Cable clamps must be purchased seperately as they are not included.
1	Torque wrench with sockets.
1	Flat head screwdriver.

About this task

You can install your access point to a pole if you do not want to drill into a concret wall. With a pole, the access point coverage area can be greater because a pole is often higher than a wall.

Procedure

Attach the KT-147407-02 to the MBO-ART03 with two M6 screws, nuts, and washers.
Attach both cable clamps to the KT-147407-02 bracket.

You open the cable clamp by inserting the head of the flathead screwdriver into the retaining screw and turning the screw counterclockwise. Then insert the nonclamp end into the KT-147407-02 through the holes.
Attach the two brackets to the pole.
Tighten the cable clamp screw around the pole by turning the screws clockwise with a flathead screwdriver.
Attach the access point to the MBO-ART03 with two M6 hex-head screws.
Adjust the two pivot points until you are satisfied.
Insert the locking bolts into the bracket and arm locking hole.
Attach the nuts and torque to 45 inch-pounds.
Tighten the pivot screws and nuts to 60 inch-pounds.
Attach the safety hanger strap as per the local code.
Adjust the LAN cable so the access point glands have a drip loop in each cable.
The LAN cable must be located on the lower side for AP460i/e, AP560i, AP560h, AP5050D and AP5050U