Install the Access Point Under-Seat

About this task

The AP560i is used with the EIO-04 mounting kit for under-seat installation.

The EIO-04 under-seat mounting kit can be installed on a:

Slope
Flat horizontal surface such as a stadium floor
Slope with EIO-GASKET to seal between the slope bracket and the riser

Note

The best practice is to install the EIO-04 under-seat mounting kit horizontally. The EIO-04 under-seat mounting kit can be installed on a 30-degree slope, a flat surface, or a stadium riser.

Note

If installing the access point on a riser, the open bottom (excluding the conduit or cable entry areas) of the service panel must be covered to minimize debris and water entry. It is especially important to cover any portion of the service panel that extends above the riser.

Procedure

Flat vertical surface such as a stadium riser

Note

Leave approximately 1-inch between the outdoor access point bottom and the floor. The gap will ensure that any water on the access point can drip off.