Install the Access Point on a Pole

Before you begin

The access point is used with the KT-147407-02 bracket parts and KT-150173-01 extension arm for pole installation. The access point is mounted on a pole by attaching:
  1. All three parts of the KT-147407-02 bracket.
  2. The KT-150173-01 extension arm with all the KT-147407-02 bracket parts.
  3. The pole bracket part of the KT-147407-02 bracket.
  4. The KT-150173-01 extension arm with the pole part of the KT-147407-02 bracket.
The following hardware is required to install the AP560i access point on a pole:
  • Flat part of the KT-147407-02 bracket
  • Pole part of the KT-147407-02 bracket
  • 1-axis tilt bracket
  • Six M6 screws
  • Two hex-head M12 stainless-steel screws
  • Two hex-heads M12 stainless-steel nuts
  • Two M12 screws
  • Two M12 hex nuts
  • 0.5 in. wide stainless-steel cable clamps
  • KT-150173-01 extension arm
Note

Note

You must provide M6 hex-head screws and screw-in anchors.
Note

Note

The cable glands must face down when you install the access point on a pole.
9036165-04 Rev AB