Install the Access Point Using KT-147407-02 Bracket Parts and KT-150173-01 Extension Arm

Before you begin

The hardware required for installation:
  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • KT-150173-01 extension arm
  • One access point
Click to expand in new window
KT-150173-01 extension arm
KT-150173-01 extension arm. There are two metal plates on either ends of the metal arm. The metal plates are flat and have four small semi-circular cuts and two large circular holes on its front face.

About this task

The KT-150173-01 extension arm is used in combination with the wall and pole bracket parts of the KT-147407-02 bracket.

Procedure

  1. Attach the flat part of the KT-147407-02 bracket to the access point using two M6 screws.
  2. Place the flat part of the KT-147407-02 bracket inside the 1-axis tilt bracket, and attach the 1-axis tilt bracket to the flat bracket using four M6 screws.
  3. Using the KT-150173-01 extension arm as a template, mark and drill four hole centers on a flat surface.
    The holes must be within the circular cuts in the end of the flange.
  4. Attach one end of the KT-150173-01 extension arm to the 1-axis tilt bracket using two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts through the two large circular holes on the KT-150173- 01 extension arm.
  5. Attach the KT-150173-01 extension arm, that now has the access point mounted on the other end, to a flat surface using four M6 size hex-head screws.

    Use screw-in anchors with the four M6 hex-head screws when you mount the bracket on a wood surface and use concrete anchors for concrete surface.

9036165-04 Rev AB