The AP560i access point can be mounted under a seat, on a wall, or to a pole, which are described in the following table.
| Mounting bracket and part number | Wall install | Pole install | Under-seat install | Notes |
|---|---|---|---|---|
| EIO-04 under-seat housing; also used with EIO-GASKET silicone rubber kit | No | No | Yes | The access point can be installed under a seat on a slope or a
flat surface such as stadium floor The EIO-GASKET silicone rubber
kit is used when the access point is installed with a small
chamfer or no chamfer (90° corner)
Note: When you mount the AP on a
riser with the metal "L" bracket only and not with a large metal sloping
bracket, it is recommended that you add a 3mm-thick stainless steel washer
between the “L” brackets and the riser on all of the anchors. The washer
provides proper drainage during storms.
|
| KT-147407-02 bracket; comes with three bracket parts | Yes | Yes | No | For attaching to a wall or a flat surface, use the bracket part that has two holes. For attaching to a pole, attach the KT-147407-02 pole part on top of the 1-axis tilt part |
| KT-150173-01; extension arm; used with KT-147407-02 bracket parts | Yes; place the KT-150173-01 extension arm on top of the 1-axis KT-147407-02 tilt part | Yes; attach the KT-147407-02 pole part to the extension arm | No | None |
| MBO-ART03 | Yes |
Yes, with the KT-147407-02 bracket. |
No |
The articulating mounting bracket is paired with the KT-147407-02 bracket. For wall installations, the wall must be strong enough to support the access point during inclement weather. |
| MBO-ART02 Note:
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It is replaced by the MBO-ART03 bracket. |
Yes | Yes | No | The articulating mounting bracket is paired with the POLE01
bracket for pole installations. For wall installations, the wall must be strong enough to support the access point during inclement weather |
| WS-MBO-POLE01 (#30520) bracket The 30520 wireless mounting kit is End of Sale (EOS). |
No | Yes (must be used with the MBO-ART02 bracket) | No | If the pole diameter is <= 1.0 in. (25.4 mm), use small cable
clamp. If the pole diameter is between 5.0 in. - 7.0 in. (178.0 mm),
use large cable clamp. For any other pole diameter, provide your own
stainless steel cable clamp. The band must be 0.5 in. (12.7 mm)
wide The POLE01 bracket can be used only when paired with the MBO-ART02 bracket |
Warning
When installing the access point on a wall or to a pole, the cable glands must face down.
Note
When using the MBO-ART02 articulating mounting bracket with the access point, set the bracket downward tilt to less than 20 degrees to prevent water ingress.