Factory Default Premier Trial License

New hardware switches include a Factory Default Premier Trial License to use all features (excluding MACsec). You can run the extend-time-period command up to three times to extend the trial license. You can configure all features, except MACsec, without restrictions and save the configuration.

Note

Note

On 5320 Series, the four highest SFP+ ports are available at 10 Gbps with Trial Licenses. After expiration, behavior is the same as with other licensed features.

You cannot configure new features after the trial period, but the switch continues to run with the existing configured features. If you reboot the switch after the trial period, and a valid software license is not present, licensed features in the configuration are not loaded. You must install a valid license to enable licensed features.

Table 1. Factory Default Premier Trial License

Platform

Initial trial period in days

5320 Series, 5420 Series, 5520 Series, and 5720 Series

30

Note

Note

The evaluation period is based on the switch System Up Time.

If a Premier license was installed and then revoked, the trial period cannot be extended.

To extend the factory default trial license, see Extend the Factory Default Premier Trial License.