Configure an Auto-sense Port Data I-SID

Before you begin

  • Enable Auto-sense on the port.

  • Associate a VLAN with the I-SID before you configure it as the data I-SID on the port. This does not apply to a DvR leaf.

About this task

Perform this procedure to configure a data I-SID on a port.
Note

Note

This option applies to the Auto-sense UNI and voice states only, it replaces the onboarding I-SID and places an (untagged) client device into a pre-defined port specific data I-SID.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the Auto-sense port data I-SID:

    auto-sense data i-sid <1-15999999>

Example

Configuring the Auto-sense data I-SID for ports 1/1 to 1/5:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/1-1/5
Switch:1(config-if)#auto-sense data i-sid 15000000

Variable Definitions

The following table defines parameters for the auto-sense data command.

Variable

Value

i-sid <1-15999999>

Specifies the service instance identifier (I-SID).