Configure a Circuitless IPv6 Interface

Before you begin

Change the VRF instance as required to configure a Circuitless IPv6 interface on a specific VRF instance.

About this task

You can use a circuitless IPv6 (CLIPv6) interface to provide uninterrupted connectivity to your system.

Procedure

  1. In the navigation pane, expand Configuration > IPv6.
  2. Click IPv6.
  3. Click the Circuitless IP tab.
  4. Click Insert.
  5. In the Interface field, assign a CLIP interface number.
  6. Type the IPv6 address and prefix length.

Circuitless IPv6 Field Descriptions

Use the data in the following table to use the Circuitless IPv6 tab.

Name

Description

Interface

Specifies the interface to which this entry applies.

Addr

Specifies the IPv6 address to which this entry applies.

AddrLen

Specifies the prefix length value for this address. You cannot change the address length after you create it. You must provide this value to create an entry in this table.

Name

Note:

This filed does not apply to 5320 Series switches.

Specifies the name assigned to the IPv6 CLIP address.