Configure Endpoint Tracking Interfaces

Create and enable Endpoint Tracking on ports and MLT/SMLT interfaces. Creating, deleting, enabling, and disabling Endpoint Tracking on interfaces can be accomplished as separate steps using this procedure.

Before you begin

  • In ExtremeCloud IQ ‑ Site Engine, configure your third-party virtualization platform, and the RADIUS server used for Endpoint Tracking authentication. For information about configuring ExtremeCloud IQ ‑ Site Engine, see the ExtremeCloud IQ ‑ Site Engine documentation at https://www.extremenetworks.com/support/documentation/.
  • On the switch, add and configure the RADIUS server as configured in ExtremeCloud IQ ‑ Site Engine.

About this task

Configure ports and MLT/SMLT interfaces to function as Switched UNI interfaces, and then create and enable Endpoint Tracking on those interfaces.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface mlt <1-512>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Enable Flex UNI on the interface:

    flex-uni enable

  3. Create and enable Endpoint Tracking:
    • Create Endpoint Tracking on the interface:

      endpoint-tracking

    • Create and enable Endpoint Tracking on the interface:

      endpoint-tracking enable

What to do next

Configure Endpoint Tracking globally on the switch.