Verifying a Multi-VRF configuration

The following examples illustrate the use of a variety of show commands that are useful in verifying Multi-VRF configurations.

Example

To verify all configured VRFs in summary mode, enter the show vrf command, as in the following example.

device# show vrf
Total number of VRFs configured: 4
VrfName                          VrfId  V4-Ucast  V6-Ucast  
corporate                        3      Enabled   Disabled  
default-vrf                      1      Enabled   Enabled  
mgmt-vrf                         0      Enabled   Enabled  
test1                            2      Enabled   Enabled  

Example

To verify a specific VRF, enter the show vrf vrf-name command, as in the following example.

device# show vrf corporate
VRF-Name: corporate, VRF-Id: 3
IP Router-Id: 1.1.1.1
Interfaces:
        Lo 10
Address-family IPV4 unicast
        Max routes:-   Route count:0
   No import route-maps
   No export route-maps

Address-family IPV6 unicast
        Max routes:-   Route count:2
   No import route-maps
   No Export route-maps

Use the show vrf detail command to display information about all VRFs.

Example

The following commands display additional information about a specific application, protocol configuration, or protocol state for both the default VRF and user-defined VRFs.

Table 1. Additional useful show commands

Default VRF	User-defined VRF
show ip route	show arp vrf
show ip ospf neighbor	show ip route vrf vrf-name
show ip bgp summary	show ip ospf neighbor vrf vrf-name
	show ip bgp summary vrf vrf-name