Configuring LACP default Up

Consider the following when using the lacp default-up command:

The command is available only if the configured interface is a dynamic member of a port-channel interface.
The command is not supported on static LAGs.
The command is not supported on port-channel interfaces.

Enter the configure terminal command to access global configuration mode.
Enter the interface command, specifying the interface type and the slot/port.
```
device(config)# interface ethernet 0/1 
```

Specify LACP default-up for the interface.

device(conf-if-eth-0/1)# lacp default-up

Enter the no form of the command to disable the configuration.
```
device(conf-if-eth-0/1)#  no lacp default-up 
```