Attaching the Mounting Bracket to the AP

1. Use 4 M4 screw assemblies to attach the AP to the “H” bracket on the side that does not have the PEM stand-offs.
2. Tighten the four screws to a torque of 12.0 in-lbs.
   

   Mounting Bracket Orientation

   
3. Secure the anchors to the wall, then secure the bracket to the anchors. See Mounting the AP3965 to a Wall.
4. If using #10 screws, tighten them to a torque of 25 in-lbs. If using ¼” screws, tighten them to 45 in-lbs.
   

   Mounting the AP3965 to a Wall

   

   

   Note

   Use anchors when mounting on cement walls. Mounting screws (shown above) are not included.