Mount the AP to a wall using the WS-MBI-WALL04
bracket
About this task
Mounting the access point to a flat ceiling
requires the WS-MBI-WALL04 (#30516) bracket, two Philips pan-head screws, and two screw-in
anchors.
Procedure
Install the WS-MBI-WALL04 bracket on a
wall or to a flat ceiling with the two screws and screw-in anchors. Ensure that the
locking tab on the WS-MBI-WALL04 bracket is on the top side during installation.
Mounting the access point using
the WS-MBI-WALL04 bracket
Use the WS-MBI-WALL04 as a template
and mark the holes to be used to mount the access point. The recommended holes are
marked "A" or "B".
Drill the holes and attach the
bracket using the screws and screw-in anchors.
Note
When using the "A" or "B" holes, if
the holes are not near the corners of the bracket, you can break off the corner to
decrease the bracket's visibility once the access point is installed.
Mounting the access point using
the WS-MBI-WALL04 bracket (when bracket corners are broken off)
Connect the LAN cable to the access
point.
Insert the access point onto the keyhole
posts and slide the access point until it lock into place.
