Mount the access point using the Main Mounting Bracket to a Flat T-bar

About this task

The access point can be mounted on a flat T-bar using the main mounting bracket that is shipped with the unit.
Pre-Installation checklist:
  • T-bar width can be either 9/16" (15 mm) or 15/16” (24 mm).
  • T-bar bottom must be flat all the way across.
  • T-bar minimum base thickness: N/A; must be structurally sound.
  • T-bar maximum base thickness: 0.055”.
  • Ceiling tile must be flat all the way across.

Procedure

  1. Attach the main mounting bracket to the access point. To know how to attach the main mounting bracket to the access point, see Mounting the AP onto the main mounting bracket.
  2. Remove the ceiling tiles, push and rotate the main mounting bracket onto the T-bar in such a way that the center angled locking tabs of the main bracket gets attached to the T-bar.
  3. Hold the access point and rock it back and forth to ensure it is securely mounted.
  4. Replace the ceiling tiles.
  5. Attach the Ethernet cable‘s RJ45 connector to the LAN1 port.
9035996-03 Rev AA