Details about how to install the
security torx locking screw on the access point.
About this task
The security torx locking screw is used to prevent the access point from being
removed from the main mounting bracket (#37201). There are two security lock screw
holes on the rear of the access point. Follow this procedure to install the security
torx locking screw using one of the security lock holes on the access point.
Note
Perform this task after the
access point is attached to the main mounting bracket on a drywall or wood
wall.
Procedure
Line up the security torx
locking screw using the rear guides on the access point.
Using a T10 bit screwdriver,
tighten the security torx locking screw.
Turn the locking screw into the security screw hole until the security torx
locking screw passes through to the other side and touches the screw stop
feature.
Security torx locking
screw stop feature
Callout
Description
1
Security torx locking screw stop feature
Note
You cannot remove the
access point from the main mounting bracket until the security torx locking
screw is removed.
