Mount the access point to a wall using the
Phillips pan-head screws
About this task
You can mount the access point directly onto
a dry or a solid wall using the Phillips pan-head screws. This is an optional installation
method and not the preferred method of installation.
Procedure
Drill two holes 104 mm (4.100”) apart
from each other on the wall where you want to mount the access point.
Insert the screws into the holes and use
the screw-in anchors, if needed.
Mounting the access point directly
on a dry or a wood wall using the Phillips pan-head screws
Insert the Ethernet cable‘s RJ45
connector into the Console port.
Align the access point against the screw
heads and slide it down.
Ensure that the access point is secured in place and tightened.
Note
When installing the access point, the
“E” logo on it must be pointing up.
If the access point is loose, unmount the access point, and decrease the distance
between the screw heads and the wall.
