ble-data-export-policy

Creates a BLE data export policy and enters its configuration mode. This policy enables forwarding of BLE (Bluetooth Low Energy) data to an external, third-party server.

The BLE data export policy provides the external, third-party server‘s REST URL. After configuring the policy apply it on an RF Domain. Once applied, BLE-enabled, WiNG APs, within the domain, sense BLE iBeacon and Eddystone beacons from other BLE-enabled devices and forward device data to the specified third-party server. This data is forwarded in the JASON format.

Note

The following WiNG access points support BLE data forwarding: AP-7612, AP7632, AP7662, AP-8432, AP-8533

Before enabling BLE data export, ensure that the APs‘ Bluetooth radio is active and the mode is set to ‘le-sensor‘. For more information on configuring the Bluetooth settings on the AP‘s profile/device context, see interface-config-bluetooth-instance.

Supported in the following platforms:

• Access Points — AP-7612, AP7632, AP7662, AP-8432, AP-8533

• Wireless Controllers — RFS 4000

• Service Platforms — NX 5500, NX 75XX, NX 95XX, NX 96XX, VX 9000

Syntax

ble-data-export-policy <POLICY-NAME>

Parameters

ble-data-export-policy <POLICY-NAME>

Examples

NOC-NX9500(config)#ble-data-export-policy test
NOC-NX9500(config-ble-data-export-policy-test)#?
Ble Data Export Policy Mode commands:
  no       Negate a command or set its defaults
  rest     Configure the url to send the real time RSSI feed to

  clrscr   Clears the display screen
  commit   Commit all changes made in this session
  do       Run commands from Exec mode
  end      End current mode and change to EXEC mode
  exit     End current mode and down to previous mode
  help     Description of the interactive help system
  revert   Revert changes
  service  Service Commands
  show     Show running system information
  write    Write running configuration to memory or terminal

NOC-NX9500(config-ble-data-export-policy-test)#

Related Commands