database-policy global config

Creates a database-policy and enters its configuration mode. After creating the database-policy, use it on the database host. This enables the database. If deploying a database replica-set, use this command to define the replica set configurations.

To enforce database authentication, enable authentication on the database-policy, and configure the username and password required to access the database. Note, this command is part of a set of configurations that are required to enable authentication. For more information on the entire set of configurations, see database (user and privi exec modes).

Supported in the following platforms:

• Service Platforms — NX 95XX, NX 96XX, VX 9000

Syntax

database-policy <DATABASE-POLICY-NAME>

Parameters

database-policy <DATABASE-POLICY-NAME>

database-policy <DATABASE-POLICY-NAME> Specify the database policy name. If the policy with the specified name does not exist, it is created.

Examples

nx9500-6C8809(config)#database-policy test
nx9500-6C8809(config-database-policy-test)#?
Database Policy Mode commands:
  authentication  Database authentication
  no              Negate a command or set its defaults
  replica-set     Replica Set
  shutdown        Disable database server

  clrscr          Clears the display screen
  commit          Commit all changes made in this session
  do              Run commands from Exec mode
  end             End current mode and change to EXEC mode
  exit            End current mode and down to previous mode
  help            Description of the interactive help system
  revert          Revert changes
  service         Service Commands
  show            Show running system information
  write           Write running configuration to memory or terminal
nx9500-6C8809(config-database-policy-test)#