Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

ip (wlan-config-mode)

Configures IPv4 settings

Supported in the following platforms:

  • Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
  • Wireless Controller — RFS4010
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

ip [arp|dhcp]
ip arp [header-mismatch-validation|trust]
ip dhcp trust

Parameters

ip arp [header-mismatch-validation|trust]
ip arp Configures the IP settings for ARP packets
header-mismatch-validation Verifies mismatch of source MAC address in the ARP and Ethernet headers. This option is enabled by default.
trust Sets ARP responses as trusted for a WLAN/range. This option is disabled by default. 
ip dhcp trust
ip dhcp Configures the IP settings for DHCP packets
trust Sets DHCP responses as trusted for a WLAN/range. This option is disabled by default.

Examples

nx9500-6C8809(config-wlan-test)#ip dhcp trust
nx9500-6C8809(config-wlan-test)#show context
wlan test
 description TestWLAN
 ssid test
 bridging-mode local
 encryption-type tkip-ccmp
 authentication-type eap
 accounting syslog host 172.16.10.4 port 2
 data-rates 2.4GHz gn
 client-load-balancing probe-req-intvl 5ghz 5
 client-load-balancing band-discovery-intvl 2
 captive-portal-enforcement fall-back
 ip dhcp trust
 acl exceed-rate wireless-client-denied-traffic 20 disassociate
 enforce-dhcp
 broadcast-dhcp validate-offer
 http-analyze controller
nx9500-6C8809(config-wlan-test)#

Related Commands

no (wlan-config-mode) Resets IP ARP or DHCP trust parameters to default. ARP trust is disabled, ARP mismatch verification is enabled, or DHCP trust is disabled.
Published June 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page