cdp
   
      
      Supported in the following platforms: 
         
         
            - Access Points — AP7502, AP7522,
               AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
 
            - Wireless Controller — RFS4010
 
            - Service Platforms — NX5500, NX7500,
               NX9500, NX9600, VX9000
 
         
       
      Syntax
      
      Parameters
cdp [receive|transmit]
               
               
               
                  
                     | receive | 
                     Enables CDP
                        packet snooping on this interface. When enabled, the port receives periodic
                        interface updates from a multicast address. This option is enabled by
                        default. | 
                  
                  
                     | transmit | 
                     Enables CDP
                        packet transmission on this interface. When enabled, the port sends out
                        periodic interface updates to a multicast address to advertise its presence
                        to neighbors. This option is enabled by default. | 
                  
               
            
 
 
      Example
nx9500-6C8809(config-profile-default-rfs4000-if-ge1)#cdp transmit
 
      Related Commands
               
               
               
                  
                     | no | 
                     Disables CDP packet snooping on the controller or service platform‘s selected GE ports |