Configuring Static PIC

About this task

To configure Static Prefix Independent Convergence, do the following:

1. Navigate to the Configuration Mode.
   

   SLX # configure terminal
   SLX (config) #

2. Execute the prefix-independent-convergence-static command to enable Static PIC.
   

   SLX (config)#prefix-independent-convergence-static
   SLX (config)#
   %Warning: Please run "clear ip[v6] route all vrf <vrf name>" for all static routes configured in VRFs

3. Exit out of the Configuration Mode.
   

   SLX (config)# exit
   SLX #

Results

When configured, if there is a link fail, the traffic is switched over ICL to the configured backup Border Leaf.

Example

This example configures Static PIC.

SLX (config)# prefix-independent-convergence-static
SLX (config)# 
%Warning: Please run "clear ip[v6] route all vrf <vrf name>" for all static routes configured in VRFs