Before you begin
The access point can be attached to a wall or flat surface with:
- KT-147407-02 (+/-15 degree tilt)
- KT-150173-01 (12 inch rigid extension)
- KT-147407-02 plus KT-150173-01 (12 inch extension plus +/-15 degree
tilt)
- MBO-ART03 (7.5", 9" or 10.5" extension plus 2 axis +/-80 degree tilt)
Note
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January,
2023. It is replaced by the MBO-ART03 bracket.
The following hardware is required when installing the access point on a flat surface
using the KT-147407-02 bracket:
- One access point
- Flat part of the KT-147407-02
bracket with two holes on the metal surface.
- 1-axis tilt bracket.
- KT-150173-01 extension arm
and associated M12 hardware. (optional)
- Six M6 screws for
KT-147407-02 bracket, and bracket to AP, assembly.
- Four M6 size hex-head screws
for attachment of the bracket to the wall.
- Screw-in anchors if the
access point is being mounted on a wood wall or a concrete surface.
Note
The M6 hex-head screws and
screw-in anchors must be provided by the installer.
If you install the access point to the wall using the ART03 bracket, use the
following hardware:
- One access point
- MBO-ART03 articulating
mounting bracket
- Four M6 hex-head screws
- Two M6 hex-head
screws to attach the bracket to the access point
- Two M6 hex-head
screws to attach the bracket to the wall or a flat surface.
Note
The cable glands
should face down when you install the access point on a wall.
