Install the Access Point on a Wall Using ACC-MBO-KT-AX Adapter and MBO-ART03 Articulating Mounting Bracket

Use the MBO-ART03 articulating mounting bracket with the ACC-MBO-KT-AX Adapter for wall installations.

About this task

Note

Note

This task only applies to the AP460C, AP460C, AP460S6C and AP460S12C.
The following hardware is required for outdoor access point wall installation using the -MBO adapter and MBO-ART03 articulating mounting bracket:
  • One outdoor access point
  • One ACC-MBO-KT-AX adapter
  • Two M5 hex bolts
  • One MBO-ART03 articulating mounting bracket
  • Four M6 hex-head screws
In addition, you need a torque wrench, a drill and a carpenter's pencil or a pen.
Attach the access point to a wall using the -MBO adapter with the MBO-ART03 articulating mounting bracket.
Note

Note

When using the MBO-ART03 articulating mounting bracket, set the maximum downward tilt to less than 20 degrees to prevent water ingress.

Procedure

  1. Attach the ACC-MBO-KT-AX adapter to the access point using the two M5 bolts.
  2. Torque the M5 bolts to 25 in-lbs.
  3. Use the MBO-ART03 articulating mounting bracket as a template, mark and drill two holes on the wall.
  4. Attach the larger face plate end of the MBO-ART03 mounting bracket to the ACC-MBO-KT-AX adapter using two M6 hex-head screws.
  5. Align the mounting holes on the ART03 bracket against the holes on the wall.
  6. Attach the ART03 bracket to the wall using two M6 hex-head screws.