Install the Plastic Service Panel on the Access Point

About this task

A service panel must be installed when the access point is installed under-bench or on a riser.

When a service panel is installed on an access point that is mounted on a riser, the service panel bottom must be closed. Keeping the service panel bottom open will enable debris to fill up, that can shorten the life of the service panel.
Note

Note

The service panel bottom opening must be closed and glued in place when not needed. The openings can be covered with at least 0.050 inches thick plastic or metal coverings.
Tip

Tip

The best practice is to use one part clear super glue and two parts epoxy to hold the service panel cover in place. This helps provide some resistance during pressure washing.
Note

Note

When installing the access point flat against a surface in a location that uses ice melt, the best practice is to apply an anti-seize material to the screws before attaching them to the access point metal base.

Procedure

  1. Attach the plastic service panel base to the access point using four, 75 mm service panel shoulder screws.
    Click to expand in new window
    Plastic service panel base views
    Base views of the service panel
    Callout Description
    1 Plastic service panel base
    2 Side view of plastic service panel base
  2. Torque the screws to 13 in-lbs.
  3. Place the service panel top over the service panel base and lock it into place using the captive screw.
    Click to expand in new window
    Plastic service panel top captive screw
    Plastic service panel top with captive screw
    Callout Description
    1 Plastic service panel top captive screw
  4. Torque the screws to 4 1/2 in-lbs.
9037683-01 Rev AC