Install the Access Point on a Pole

Before you begin

The access point is used with the KT-147407-02 bracket parts and KT-150173-01 extension arm for pole installation. The access point is mounted on a pole by attaching:

All three parts of the KT-147407-02 bracket.
The KT-150173-01 extension arm with all the KT-147407-02 bracket parts.
The pole bracket part of the KT-147407-02 bracket.
The KT-150173-01 extension arm with the pole part of the KT-147407-02 bracket.

The following hardware is required to install the access point on a pole:

All parts of the KT-147407-02 bracket
Six M6 screws
Two hex-head M12 stainless-steel screws
Two hex-heads M12 stainless-steel nuts
0.5 in. wide stainless-steel cable clamps
KT-150173-01 extension arm

Note

You must provide M6 hex-head screws and screw-in anchors.

Note

The cable glands must face down when you install the access point on a pole.