Install the Access Point Using
KT-150173-01 Extension Arm
Before you begin
Obtain the following hardware:
KT-150173-01 extension
arm
Four M6 screws
Four M6 hex-head screws
One access point
About this task
Install your access point with an extension arm if a standoff distance—but no tilt—is
required. The KT-150173-01 extension arm provides a minimum standoff distance of
twelve inches and helps avoid interference with the antennas.
KT-1501730-01 Extension
Arm Attachment Holes
Callout
Description
1
Extension arm attachment holes
Procedure
Using the KT-150173-01 extension
arm as a template, mark and drill four hole centers on a flat surface.
The holes must be within the
circular cuts in the end of the flange. See the diagram above.
Attach one end of the
KT-150173-01 extension arm to the access point using four M6 screws.
Attach the other end of the
KT-150173-01 extension arm to the wall using four M6 hex-head screws.
Use screw-in anchors with the four M6 hex-head screws when you mount the
bracket on a wood surface and use concrete anchors for concrete surface.
