Resets one or all OSPFv3 interfaces to the
default settings.
Syntax Description
area_identifier
Specifies an OSPFv3 area, a
four-byte, dotted decimal number.
vlan_name
Specifies an IPv6 configured
VLAN.
tunnel_name
Specifies an IPv6
tunnel.
Default
N/A.
Usage Guidelines
ExtremeXOS
OSPFv3 allows you to change certain configurable OSPFv3 parameters
on the fly. This command selectively resets the configurable parameters
to their default values. The following is the list of parameters
whose values will be reset to their defaults:
Interface:
Hello Interval.
Dead Interval.
Transmit Delay.
Retransmit Interval.
Priority.
Cost.
Area:
All the parameters of Interfaces associated with
this area.
Inter-Area-Prefix-LSA Filter.
AS-External-LSA Filter.
OSPFv3 Global:
SPF Delay interval.
Interface Cost metric Table.
Route Redistribution.
Example
The following command
resets the OSPFv3 interface to the default settings on the VLAN
accounting:
unconfigure ospfv3 accounting
The following command unconfigures the parameters
of the area 0.0.0.1 (and all its associated interfaces):
unconfigure ospfv3 area 0.0.0.1
History
This command was
first available in ExtremeXOS 11.2.
