Configure SCI Tagging for a MACsec Enabled Switch

About this task

Use the following procedure to configure SCI tagging on a MACsec-enabled switch. The default is enabled.

Note

Note

The configuration should be the same at both ends of the link, either enabled or disabled.

If you are running VOSS 8.4.2 or earlier, disable SCI tagging on the switch.

Note

Note

This procedure only applies to VSP 8400 Series, VSP 4900 Series, and 5520 Series.

Procedure

  1. Enter mka profile Configuration mode:

    enable

    configure terminal

    macsec mka profile WORD<1-16>

  2. To disable SCI tagging on the switch, enter:

    no include-sci enable

  3. To restore SCI tagging to the default value, enter:

    default include-sci enable