time-it (user and privi exec modes)

Verifies the time taken by a particular command between request and response
Note

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

  • Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
  • Wireless Controller — RFS4010
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

time-it <COMMAND>

Parameters

time-it <COMMAND>

time-it <COMMAND>

Verifies the time taken by a particular command to execute and provide a result

  • <COMMAND> – Specify the command.

Examples

ap8432-070235>time-it enable
That took 0.00 seconds..
ap8432-070235#

Example (Privi Exec Mode)

rfs4000-229D58#time-it config terminal
Enter configuration commands, one per line.  End with CNTL/Z.
That took 0.00 seconds..
rfs4000-229D58(config)#